3
Using the Module
Set up the Detector with Agilent Open Lab ChemStation
Set up the Detector with Agilent Open Lab
ChemStation
The setup of the detector is shown with the Agilent OpenLab ChemStation
C.01.07 and Driver A.02.14.
This section describes the detector settings only. For information on the Agilent
NOT E
OpenLab ChemStation or other 1200 Infinity modules refer to the corresponding
documentation.
Figure 14
After successful load of the OpenLab ChemStation, you should see the module
as an active item in the graphical user interface (GUI).
Agilent InfinityLab LC Series Diode Array Detectors User Manual
ChemStation Method and Run Control (just detector is shown)
44