Setting Up The Detector With Agilent Chemstation - Agilent Technologies 1200 Infinity Series User Manual

Setting up the Detector with Agilent ChemStation

The setup of the detector is shown with the Agilent ChemStation B.04.02
based on the 1290 Infinity DAD (G4212A). Depending on the controller (e.g.
Agilent Instant Pilot, EZChrom Elite, MassHunter) the screens look different.
For the Instant Pilot refer to
Instant Pilot (G4208A)"
This section describes the detector settings only. For information of the Agilent
N O T E
ChemStation or other Agilent 1260 Infinity/1290 Infinity Series modules refer to the
corresponding documentation or system manual.
After successful load of the ChemStation, you should see the module as an
active item in the graphical user interface (GUI).
Agilent 1200 Infinity Series DAD User Manual

Setting up the Detector with Agilent ChemStation

"Main Screens of the Detector with Agilent
on page 69.
4
Using the Module
51