ELECTRICAL COMPONENTS
SOLID STATE SPEED CONTROLLER
See General Warning, Section 10, Page 10-1.
Testing the Solid State Speed Controller
See Test Procedure 5, Section 11, Page 11-21.
Speed Controller Removal
1. Disconnect the batteries and discharge the controller. See Disconnecting The Batteries on page 10-3.
2. Remove the rear body access panel.
3. Remove the two screws (5) from the speed controller cover (1) and remove the cover (Figure 13-10,
Page 13-11).
4. Disconnect all wires and multi-pin connectors from the speed controller (Figure 13-11, Page 13-12).
3
Figure 13-10 Speed Controller Cover
2008-2011 IQ System Electric Vehicle Maintenance and Service Supplement
Solid State Speed Controller
5
1
2
13
Page 13-11