Reset All Settings - Club Car DS Villager 4 Maintenance And Service Manual Supplement

IQ DISPLAY MODULE (IQDM) SERIES 2 AND IQDM-P DIAGNOSTICS
6. Select settings.
7. Select write settings to controller.
8. Press + on the change value button to confirm the operation.
9. The handset will display an "executing..." message for the next few seconds while the controller settings
are being stored in the handset's memory (Figure 12-4).
10. When the handset is finished transferring the speed controller settings, a confirmation message is dis-
played (Figure 12-6).
11. Repeat this procedure for additional vehicles that need to be programmed with the same handset set-
tings.
All Controller Settings
Set from Programmer.
OK (+) OK (+)
Figure 12-6 Confirmation Message

RESET ALL SETTINGS

In the event that a mistake was made and one or more changes should not have been made with the handset,
the speed controller settings can be reverted to the original settings from the beginning of the session (when
the handset was plugged into the vehicle). This function is similar to the "undo" command on a PC and will
work correctly only when the handset has not been unplugged and power to the speed controller has not
been interrupted.
2008-2011 IQ System Electric Vehicle Maintenance and Service Supplement
All Controller Settings
Reset to Original Values.
OK (+) OK (+)
Figure 12-7 Confirmation Message
12
Functions Menu
Page 12-13