Tow/Run Switch; Motor Controller Output Regulator (Mcor) - Club Car DS Villager 4 Maintenance And Service Manual Supplement

ELECTRICAL COMPONENTS
11
Figure 13-4 Forward/Reverse Rocker Switch
(DS Villager 4)

TOW/RUN SWITCH

See General Warning, Section 10, Page 10-1.
Testing the Tow/Run Switch
See Test Procedure 6, Section 11, Page 11-21.
Tow/Run Switch Removal
1. Disconnect the batteries and discharge the controller. See Disconnecting The Batteries on page 10-3.
2. Remove Tow/Run switch boot/hex nut (6) (Figure 13-3, Page 13-4).
3. Remove Tow/Run switch (10) and nut (9) from bracket (5).
4. Disconnect the two-pin connector (7) and remove switch.
Tow/Run Switch Installation
1. Installation is reverse of removal. Make sure groove on switch is aligned with tang on bracket. Tighten
Tow/Run switch boot/hex nut (6) to 16 in-lb (1.8 N·m) (Figure 13-3, Page 13-4).
2. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector Spray
(CC P/N 1014305) to minimize corrosion.

MOTOR CONTROLLER OUTPUT REGULATOR (MCOR)

See General Warning, Section 10, Page 10-1.
Testing the MCOR
See Section 11, Test Procedure 4, Page 11-19 and Test Procedure 8, Page 11-23.
2
3
2008-2011 IQ System Electric Vehicle Maintenance and Service Supplement
11
Figure 13-5 Forward/Reverse Rocker Switch
(Turf 1/ Carryall 1)
13
Tow/Run Switch
13
Page 13-5