Transaxle; Transaxle Removal - Club Car DS Villager 4 Maintenance And Service Manual Supplement

TRANSAXLE (TYPE G)

TRANSAXLE

See General Warning, Section 10, Page 10-1.

TRANSAXLE REMOVAL

1. Place chocks at the front wheels and slightly loosen lug nuts on both rear wheels.
2. Place a floor jack under the transaxle and raise the rear of the vehicle. Position jack stands under the
frame crossmember between the spring mount and the side stringer, just forward of each rear wheel.
Lower the vehicle to let the jack stands support the vehicle (Figure 17-6, Page 17-5). See WARNING
"Lift only one end of the vehicle..." in General Warning, Section 10, Page 10-1.
3. Remove the rear wheels, then thread one lug nut onto a stud on each rear hub. This will keep the brake
drums on the hubs.
4. Remove the bow tie pins (1), brake cable clevis pins (2), and cable retaining E-clips (3). Disconnect the
brake cables (4) (Figure 17-7, Page 17-5).
Figure 17-6 Vehicle Supported on Jack Stands
Figure 17-8 Disconnect Shocks
2008-2011 IQ System Electric Vehicle Maintenance and Service Supplement
2
4
3
Figure 17-7 Brake Cables
Remove bolts, then
rotate shackles
up and away
from spring.
Figure 17-9 Shackles
17
Transaxle
1
Page 17-5