Onboard Computer (Obc) - Club Car DS Villager 4 Maintenance And Service Manual Supplement

ELECTRICAL COMPONENTS

ONBOARD COMPUTER (OBC)

See General Warning, Section 10, Page 10-1.
Testing the Onboard Computer
See Section 11, Test Procedure 2, Page 11-18, Test Procedure 10, Page 11-35, and Test Procedure 11,
Page 11-35.
Onboard Computer Removal
1. Disconnect the batteries and discharge the controller. See Disconnecting The Batteries on page 10-3.
2. Remove rear body access panel and unplug the six-pin connector (16) at the OBC (Figure 13-9,
Page 13-9).
3. Remove the two screws (5) from the speed controller cover (1) and remove the cover (Figure 13-10,
Page 13-11).
4. Remove the wire tie (3) securing the speed controller wires to the mounting plate.
5. Remove black 6-gauge wire (14) from the speed controller B– terminal (Figure 13-9, Page 13-9).
6. Disconnect the gray wire fuse holder at the charger receptacle.
7. Disconnect the black 10-gauge wire (8) at the charger receptacle.
8. Cut the wire tie that secures the OBC wire harness to the I-beam.
9. Loosen, but do not remove, the two self-tapping screws (17) holding OBC to component mounting plate.
10. Slide OBC towards outside of vehicle and align heads of self-tapping screws (17) with the two holes in
the OBC face plate. Pull OBC towards rear of vehicle and remove from component mounting plate.
13
14
8
17
Figure 13-9 Onboard Computer
2008-2011 IQ System Electric Vehicle Maintenance and Service Supplement
2
1
14
7
10
6
8
9
16
13
Solenoid
Page 13-9