Spare Parts; Care And Maintenance - horsch Maestro 16 SX Operating Instructions Manual

2 | Safety and responsibility

2.11 Spare parts

2.12 Care and maintenance

18
Genuine spare parts and accessories from HORSCH have been specially designed for
this machine.
Spare parts and accessories which are not delivered by us have not been tested or
approved by us.
The installation or use of other than HORSCH products can therefore negatively af-
fect the design characteristics of the machine and thus impair the safety of man and
machine.
HORSCH will not assume liability whatsoever for damage resulting from the use of
non-original parts and accessories.
If the component to be replaced is marked with a safety sticker, these stickers must
also be ordered and attached to the spare part.
Inappropriate care and maintenance put the operational safety of the machine at
risk. This can lead to accidents with severe or even fatal physical injuries.
Ø Conform to prescribed schedules for repetitive tests or inspections.
Ø Service the machine according to the maintenance plan, see chapter Care and
maintenance.
Ø Only perform the work described in these operating instructions.
Ø Before starting maintenance and service work park the machine on level and
firm ground and secure it against rolling away.
Ø Depressurise the hydraulic system and lower or support the implement.
Ø Prior to working on the electrical system, disconnect it from the electric cur-
rent supply.
Ø When performing welding work on the machine, disconnect the cables from
electronic components. The ground connection must be as close as possible to
the welding point.
Ø Before cleaning the machine with high pressure cleaner cover all openings,
which should stay clear of water, steam or cleaning agents for reasons of
safety or operation. Do not aim the water jet directly on electric or electronic
components or bearings. When cleaning with high-pressure cleaning equip-
ment or steam jet always keep a distance of at least 50 cm to machine com-
ponents.
Ø After cleaning, check all hydraulic lines for leaks and loose connections.
Ø Check for chafing and signs of damage. Remedy any faults immediately!
Ø Retighten screw connections loosened for care and maintenance work.
Ø Do not clean new machines with a steam jet of a high pressure cleaner. The
paint takes approx. 3 months to cure and could be damaged before this time.
Ø Danger of explosion! Do not exceed the specified tire pressure, see Mainten-
ance overview.
NOTE
All other maintenance and repair tasks, which are not described in the operating in-
structions, must only be carried out by an authorized professional workshop or by
an operator who has been trained by HORSCH for this purpose.
60026387 • 01 • 03/2021 • en