Table of Contents
Advertisement
Point Name/Description
Input 8 Function – The usage of Input 8. You must also set Input 8 Switch
Configuration.
Options:
No Function – The input is not used.
Enthalpy Switch – Indicates enthalpy status (high or low).
Fan Status – Proves supply fan operation.
Filter Status – Indicates a dirty filter.
Remote Occupancy – Sets occupancy using a hardware contact.
Door Contact – Sets occupancy using a hardware contact.
Input 9 Function – The usage of Input 9. You must also set Input 9 Switch
Configuration.
Options:
No Function – The input is not used.
Humidistat – Indicates high humidity condition.
Fan Status – Proves supply fan operation.
Filter Status – Indicates a dirty filter.
Remote Occupancy – Sets occupancy using a hardware contact.
Door Contact – Sets occupancy using a hardware contact.
IGC Override – Monitors the flame output from the Integrated Gas Control board. The
input detects if a flame is still present after heating has been disabled.
Status - Equipment Touch
Navigation:
Equipment Touch:
Point Name/Description
Equipment Status – The controller's current status.
System Mode – The controller's current operating mode.
Supply Fan Status – The current fan status if an input is configured for Fan Status.
Fan / Speed – The current commanded fan speed if Fan Control is set to Two Speed.
RTU Open v3
Installation and Start-up Guide
Appendix C: RTU Open Points/Properties on the Equipment Touch
Status
97
Range
D:
Enthalpy Switch
R:
No Function
Enthalpy Switch
Fan Status
Filter Status
Remote Occupancy
Door Contact
D:
Humidistat
R:
No Function
Humidistat
Fan Status
Filter Status
Remote Occupancy
Door Contact
IGC Override
Range
R:
Disabled
Test
Run
R:
Off
Fan Only
Economizer Cooling
Cooling
Heating
Dehumidification
Test
Shutdown
Unocc Free Cooling
Fire Shutdown
IAQ Override
Pre-occ Purge
R:
Off/Running
R:
Off/Low/High
CARRIER CORPORATION ©2019
All rights reserved
Advertisement
Table of Contents
