Enter Shock Sensor Adjustment Mode; Adjusting The Shock Sensor Setting - Directed Electronics 10 Owner's Manual

Directed electronics state-of-the-art vehicle security system owner's guide 10

Table of Contents

s s h h o o c c k k s s e e n n s s o o r r a a d d j j u u s s t t m m e e n n t t

➜

enter shock sensor adjustment mode

important: : Prior to performing this procedure the system

must be disarmed, the doors, trunk and hood must be

closed, and the ignition must be Off.

1. Press and hold

2. The system will emit 1 long chirp to indicate entry into

shock adjustment mode.

3. The LED will illuminate continuously for the duration of

shock adjustment mode.

note: : When the shock sensor adjustment mode is entered,

all other timers and operations are bypassed until adjust-

ment mode is exited.

➜

1. Increase Sensitivity—Press and release the

increase shock sensor sensitivity by one step. The siren will

chirp 2-times for each step increased in adjustment. When

the shock sensor adjustment reaches maximum sensitivity

the siren will emit 2 short chirps and then 1 long chirp.

n n o o t t e e : : When the arm and disarm are programmed to a sin-

gle button, then the AUX button is used to increase the

sensitivity setting of the sensor.

and

buttons for 6-seconds.

button to

Table of Contents

Clifford 10