Disarming Without A Transmitter - Directed Electronics Hurricane 3 Owner's Manual

longer than six seconds, press
the system to its armed state. Pressing
disarm the system. To disarm the system immediately, press
during the first six seconds of the Triggered Sequence.

Disarming Without a Transmitter

If your remote transmitter is lost or damaged, you can manually
disarm your vehicle security system. To disarm the system without
a transmitter, you must have the vehicle's ignition key and know
where the Valet switch is located. Be sure to check with your
installer at the time of installation for both the location and the
preset response (1-5 presses) of the Valet switch.
To disarm the security system,
turn the ignition key on and
press the Valet switch the preset
number of times (1-5 presses)
within 15 seconds. If the system
does not disarm, you may have
waited too long to press the
Valet switch; turn the ignition
off and repeat the process.
IMPORTANT! The Valet switch can be programmed to respond to 1-5
presses for the disarm function. You must check with the installer to ver-
ify the programming for your individual unit.
LOCATION OF VALET SWITCH______________________________
2000 Directed Electronics, Inc.
©
to stop the trigger and reset
an additional time will
DRW-35
9