Burners And Igniters - DCS RGT484GGSS Use And Care Manual

CARE AND MAINTENANCE
bURNERS
For proper lighting and performance keep the
burners clean. It is necessary to clean the burners
they do not light even though the ignit-
clicks, if there has been a severe boil over,
when the flame does not burn blue. Be certain all
burner knobs are in the off position before attempting
clean the burners. The burners have been designed
for ease in cleaning. When the grates and burners
are cool, remove the grate. The burner cap and the
brass port ring can easily be lifted off. Wash these
parts in hot soapy water, rinse and dry thoroughly.
The burner caps are porcelain enamel, follow the
directions on the previous page that were given
for the burner grates. A bristle brush can be used
to clean out the toothed burner ports, if necessary.
disassembly of the simmer ring is not recommended,
however, it may become necessary to do so if the
ports remain clogged after normal cleaning. If it
necessary to disassemble the simmer ring from the
base, remove the hex nut at the top of the simmer
ring. Clean the simmer ring with hot soapy water
using a soft wire or plastic bristle brush then dry
thoroughly. Re-assemble the parts using the hex
nut. After cleaning, it is important to make sure
the locating pin on the bottom side of the sim-
mer ring is properly aligned with the corresponding hole in the base and that the
two locating pins (see insert-Fig.15) in the bottom side of the brass port ring are
properly aligned with the locating notch and center holes on the top side of the sim-
mer ring. Incorrect alignment will produce a potentially dangerous flame and poor
burner performance (see Fig. 15).
IGNITERS
Wipe with a rubbing alcohol dampened cotton swab. Be careful not to damage the
igniter (see Fig. 16).
SUMp AREA AROUND bURNERS AND IGNITERS
Remove grates. With a warm wet sponge, apply a soap that
will release grease (like dawn). Clean up soiled area around
sump.
fOR hARD TO ClEAN SOIl, USE ThIS METhOD:
If residue is still left, make
per collar around the burner and igniter and tape it togeth-
(Fig. 17). spray "Easy off" or "sos" oven spray using the cool
method on soiled area. Cover it with a paper towel and leave
it on the area at least 4 hours or overnight (Fig. 18). With
warm moist sponge, remove the oven spray and soil. dry with a soft cloth.
DRIp TRAyS AND DRAIN TUbES
If you have a griddle or a grill there will be a tray liner located inside
the drip tray (Fig. 19). The drip trays are made of stainless steel. The drip trays
are on rollers so they are easy to remove and replace.
BRAss RING
loCATING PIN
loCATING
NoTCH
ElECTRodE
loCATING PIN
HolE INsIdE
fig. 15
TAPE
fig. 17
CAP
MAIN
BURNER
PoRT RING
loCATING PIN
HEx NUT
sIMMER
RING
loCATING PIN
BURNER
BAsE
vENTURI
IGNITER (kEEP ClEAN)
fig. 16
the
a
fig. 18
dRAIN
TUBEs
dRIP TRAY ANd lINER
fig. 19
23
if
er
or
to
is
pa-
er
a
of