Cooktop Use; Using The Cooktop Burners - DCS RDU-305 User Manual

Cooktop use

24
US
CA

Using the cooktop burners

Identify the knob of the burner you want to
1
use.
When the burner has lit, turn the knob to
3
any setting between HI (high) and SIM
(simmer).
The clicking should stop as soon as the
burner has lit.
If the burner doesn't light, and/or the
clicking doesn't stop, or the flames are
not blue and well-defined, turn the
knob clockwise back to OFF and see
'Troubleshooting' for advice.
Halo
(Red)
Push the knob in and turn it counterclockwise
2
to LITE.
Make sure you stop at LITE before turning the
knob to any flame setting.
The halo will glow red.
You will start hearing a clicking sound. If there
is no clicking, turn the knob clockwise back to
OFF and see 'Troubleshooting' for advice.
When you have finished cooking, turn the
4
knob clockwise back to OFF.
The knob will release and the burner and
halo will go out.
If you are using LP gas, there may be a
slight 'extinction pop' or flash at the flame
spreader a few seconds after the burner has
been turned off. This is normal for LP gas.
Halo
(Red)
Halo
(Unlit)