Cooktop Use; Using The Cooktop Burners - DCS RGU-366 User Manual

Cooktop use

24
US
CA

Using the cooktop burners

Identify the knob of the burner you want to
1
use.
When the burner has lit, turn the knob to
3
any setting between HI (high) and SIM
(simmer).
The clicking should stop as soon as the
burner has lit.
If the burner doesn't light, and/or the
clicking doesn't stop, or the flames are
not blue and well-defined, turn the
knob clockwise back to OFF and see
'Troubleshooting' for advice.
2
Halo
(Red)
4
Push the knob in and turn it counterclockwise
to LITE.
Make sure you stop at LITE before turning the
knob to any flame setting.
The halo will glow red.
You will start hearing a clicking sound. If there
is no clicking, turn the knob clockwise back to
OFF and see 'Troubleshooting' for advice.
When you have finished cooking, turn the
knob clockwise back to OFF.
The knob will release and the burner and
halo will go out.
If you are using LP gas, there may be a
slight 'extinction pop' or flash at the flame
spreader a few seconds after the burner has
been turned off. This is normal for LP gas.
Halo
(Red)
Halo
(Unlit)