Viewing The Wireless Network Information - Yealink SIP-T46S User Manual

User Guide for the SIP-T46S IP Phone
Press the WPS soft key, and then select WPS-PIN from the prompt list.
3.
The LCD screen prompts "Please input below PIN code on your Wi-Fi router and press OK
to start connecting: xxx".
Log into your gateway/router's web interface, and configure it to search the clients. For
4.
more information, refer to the documentation from the gateway/router manufacturer.
Once WPS-PIN setup has completed successfully, the gateway/router's web interface will
prompt success.
Note Contact your gateway/router provider for more information.
Manually Add a Wireless Network
If your gateway/router has SSID broadcast disabled, it might not appear in the scanning results.
In that case, you must manually add a wireless network.
To add a wireless network:
Press Menu->Basic->Wi-Fi.
1.
Press
2.
Use the WLAN settings obtained from your gateway/router to configure this WLAN Profile
3.
on the IP phone. Do the following:
If you select None or WEP from the pull-down list of Security Mode:
a)
Enter the profile name, SSID and WPA shared key in the corresponding fields.
If you select WPA-PSK or WPA2-PSK from the pull-down list of Security Mode:
b)
Select the desired Cipher type (TKIP, AES or TKIP AES) from the pull-down list of
Cipher Type.
Enter the profile name, SSID and WPA shared key in the corresponding fields.
Press the Save soft key to accept the change or the Back soft key to cancel.
4.
The connected wireless networks will be saved to Known network list. The Known network list
can store up to 5 wireless networks, you can specify the priority to connect to the corresponding
wireless network.

Viewing the Wireless Network Information

To view the wireless network information via phone user interface:
Press Menu->Basic->Wi-Fi->X Available Network(s) (X represents the number of
1.
available networks).
Press
2.
Press the Detail soft key to view the detailed wireless network information (e.g., Profile
3.
Name, SSID or Signal Strength).
32
or to highlight Known network, and then press the Add soft key.
or to highlight the desired wireless network.