Attended Transfer; Call Waiting - Yealink SIP-T46S User Manual

User Guide for the SIP-T46S IP Phone

Attended Transfer

Before performing an attended transfer (except you use dial number method), make sure that
the transfer mode on DSS key is configured as New Call or Attended Transfer. For more
information on how to configure it, refer to
166.
To perform an attended transfer:
Press
1.
Do one of the following:
2.
Enter the number you want to transfer the call to.
-
Press
Press the Directory soft key, and then select Local Directory. Select the desired
-
group and search for the contact (Directory should be configured in advance. Refer to
Directory
Press
Press the Directory soft key, and then select History. Select the desired list and then
-
press
Refer to
Press
Press the Directory soft key, and then select Remote Phone Book. Select the desired
-
group and search for the contact (Directory should be configured in advance. Refer to
Directory
Press
After the party answers the call, press
3.
transfer.
If you are using a handset, the transfer can be completed by hanging up the handset.
You can cancel the transfer before the call is connected by pressing the Cancel soft key.

Call Waiting

You can enable or disable call waiting on the phone. If call waiting is enabled, you can receive
another call while there is already an active call on the phone. Otherwise, another incoming call
is automatically rejected by the phone with a busy message when there is an active call on the
phone. You can also enable or disable the phone to play a warning tone when receiving another
call.
To configure call waiting via phone user interface:
Press Menu->Features->Call Waiting.
1.
Press
2.
144
or the Transfer soft key during a call.
or to dial out.
on page 59 for more information).
, or the Send soft key to dial out.
or to select the entry (Directory should be configured in advance.
Directory on page 59
, or the Send soft key to dial out.
on page 59 and Remote Phone Book
, or the Send soft key to dial out.
or , or the Switch soft key to select Enabled from the Call Waiting field.
Configuring Transfer Mode on DSS Key
for more information).
on page
or the Transfer soft key to complete the
on page
76 for more information).