Wireless Network Settings - Yealink SIP-T46S User Manual

User Guide for the SIP-T46S IP Phone
the IP mode is configured as IPv6 or IPv4 & IPv6.
To configure a static IPv6 address via phone user interface:
Press Menu->Advanced (default password: admin) ->Network->WAN Port
1.
Press
2.
Press
3.
Enter the desired value in the IP Address, IPv6 IP Prefix, Default Gateway, Pri.DNS and
4.
Sec.DNS field respectively.
Press the Save soft key to accept the change or the Back soft key to cancel.
5.
Note The wrong network settings may result in inaccessibility of your phone and may also have an
impact on your network performance. For more information on these parameters, contact your
system administrator.

Wireless Network Settings

Wi-Fi is a popular wireless networking technology that uses radio waves to provide wireless
high-speed Internet and network connections. You can activate/deactivate the Wi-Fi mode on
the IP phone, and then connect your phone to the desired wireless network.
Ensure that the Wi-Fi USB Dongle WF40 is properly connected to the USB port at the back of the
Note
IP phone. For more information, refer to
28
or to select IPv6 and then press the Enter soft key.
or , or the Switch soft key to select the Static IP from the Type field.
Phone Installation on page 20.