Yealink SIP-T46S User Manual page 126

User Guide for the SIP-T46S IP Phone
Using the speakerphone

Using the headset

You can also dial the number first, and then choose the way you want to speak to the other
party.
You can also search and dial a contact from call history, local directory or remote phone book.
For more information, refer to
on page 78.
During a call, you can alternate between Speakerphone, Headset, and Handset modes by
pressing the Speakerphone key, the HEADSET key, or by picking up the handset.
The call duration of the active call and far-site's information (name or phone number) are visible
on the LCD screen. In the figure below, the call to "1026" (the phone number: 1026) has lasted
15 seconds.
To place a call using the handset:
Pick up the handset.
1.
Enter the desired number using the keypad.
2.
Press
3.
The # key is configured as a send key by default. You can also set the * key as the send key, or
set neither. For more information, refer to the
You can also dial using the SIP URI or IP address. To obtain the IP address of a phone, press the
Note
OK key when the phone is idle. The maximum length of SIP URI or IP address length is 32
characters. For example, SIP URI: 3606@sip.com, IP: 192.168.1.15 (192*168*1*15).
Your phone may not support direct IP dialing. Contact your system administrator for more
information.
To place a call using the hands-free (speakerphone) mode:
Do one of the following:
With the handset on-hook, press
-
Enter the desired number using the keypad.
Press
116
Contact Management
, , or the Send soft key.
, or the Send soft key.
on page 59 and Call History Management
Key As Send on page 51.
or the line key to obtain a dial tone.