WAGNER PEA-C4 Twin-HiCoat Operating Manual page 19

Maintenance and cleaning
Hint
For inserting the protective wedge the same wedge tool will be used.
Proceed as described below:
You will find the necessary wearing parts and spare parts in chapter
09/2014
1
Wedge tool
2
Protective wedge
3
Electrode holder (cut open view)

Guide the protective wedge
wedge tool

Insert both parts in the opening on the
electrode holder 3 to the stop.

If it is not possible to push the wedge tool in
as far as the mark
a little until it can be pushed into the mark.
The mark
the electrode holder.

The protective wedge is now correctly
assembled and the wedge tool can be
pulled back out of the electrode holder.
The protective wedge remains inserted in
the electrode holder.
390832
-
PEA-C4 Twin-HiCoat
2
into the
1.
X,
rotate the wedge tool
X
must be flush with the end
8.2 of this manual.
Y
of
19