Continuous Mode - Newland NLS-HR11 User Manual

Continuous Mode

Continuous Mode: A trigger press activates the scanner to scan and decode at user-specified intervals,
i.e. the timeout between decodes. Each decode session lasts until barcode is decoded or the decode
session timeout expires. To suspend/resume the operation, simply press the trigger. By default, the
scanner rereads same barcode with no delay.
Decode Session Timeout: This parameter sets the maximum time decode session continues during a
scan attempt. It is programmable in 1s increments from 1s to 255s. The default timeout is 15s. If the
parameter is set to 0, the decode session timeout is infinite.
Example: Set the decode session timeout to 5s
1. Scan the Enter Setup barcode.
2. Scan the Decode Session Timeout barcode.
Scan the numeric barcode "5". (See the Digit Barcodes section in Appendix)
3.
4. Scan the Save barcode. (See the Save/Cancel Barcodes section in Appendix)
5. Scan the Exit Setup barcode.
47
Continuous Mode
Decode Session Timeout
** Enter Setup
Exit Setup