Automatic Heating And Foaming; Automatic Heating; Manual Heating And Foaming; Automatic Cleaning - Wega Concept Use And Maintenance Manual

Wegaconcept
To obtain optimal foaming, it is recommended to
observe the following simple rules:
• heat only the amount of milk you intend to use, once
heated, the milk will have to be completely poured
from the jug and mustn't be heated again;
• the autosteamer guarantees a correspondence of
± 3°C between the set temperature and the real
temperature of the milk, only by starting from a milk
temperature of 4°C;
• since the delivery of steam stops on its own when
the set temperature of milk is reached, to prevent the
milk foam spilling out, it is necessary to introduce a
volume of liquid not higher than 1/2 the capacity of
the jug.
• use a container with a capacity of 0.75 litres and half-
fi ll it with milk;
• set a maximum heating temperature of 60 °C (contact
the technical support).
15.2

Automatic heating and foaming

Proceed as follows:
• Immerge the tips of the autosteamer
(13) into the beverage;
• press the or
on the dose of milk in the jug;
• wait until the delivery is fi nished;
• when the delivery is fi nished, the milk
will be foamed and heated at the preset
temperature.
• To stop delivery in advance, press the same key
again;
• to prolong the delivery of steam, use the "Manual
steam" key.
To increase or decrease the consistency of the foam,
slightly adjust the special regulator (A). Turning it
clockwise will decrease the consistency, while turning
it counter-clockwise will increase it.
Always proceed by performing slight adjustments.
26
13
key, depending
!
The autosteamer foaming is factory-adjusted
during the testing phase of the machine. Therefore,
it is recommended to modify the adjustment only
if strictly necessary.
15.3

Automatic heating

Proceed as follows:
• Immerge the tips of the autosteamer (
beverage;
• press the
• wait until the delivery is fi nished;
• once the delivery is fi nished, the milk will be heated
at the programmed temperature, but not foamed.
• To stop delivery in advance, press the same key
again;
• to prolong the delivery of steam, use the "Manual
steam" key.
15.4

Manual heating and foaming

This control allows for manual use of the autosteamer
nozzle to heat and foam the milk at the same time.
Proceed as follows:
• Immerge the tips of the autosteamer (
beverage;
• press the
• To stop delivery, press the same key again.
15.5

Automatic Cleaning

After idling for 120 minutes the automatic cleaning of
the nozzle starts, lasting 15 seconds.
The following message will appear on the display:
"STEAM CLEANING CYCLE"
A minimum amount of steam will come out of the
nozzle.
!
The use of the steam delivery point (steam nozzle),
must always be preceded by condensation draining
for at least 2 seconds.
A
key;
key;
Technical manual
13) into the
13) into the