BLUM MINIPRESS P Operator's Manual page 7

• Do not operate the machine with any cover or panel removed.
• Eye protection required at all times while setting up, operating, or servicing this machine.
• Keep all body parts clear of point of operation when machine power is on.
• Machine components might be pressurized even when power is off.
• Regulated air pressure must not exceed 100 psi (6.9 bar).
• Disconnect electrical power from the machine before removing any cover or panel.
• Disconnect electrical power and air supply, and release stored air pressure from machine before performing maintenance and
service operations.
• Maintenance and service must be performed by qualified and authorized personnel only.
• Operators and service personnel must follow all LOCKOUT / TAGOUT procedures established by management.
• Always turn power switch
• Particular care must be taken when working on sections that extend out over the worktable. Attach a larger work table or use
extensions.
• Secure the work piece during boring/insertion. Use the machine clamps or if these are not sufficient for the particular job, use
suitable clamping equipement.
• You should always check that all safety devices and machine parts are functioning properly before use. Replace damaged parts
with original Blum parts.
• Make sure that no other tools or objects are on the work table aside from your work piece before turning on the machine.
• After finishing work, disconnect the machine from the power supply.
• CAUTION: For your own safety, use only those accessories which are recommended or indicated in the manual or Blum sales
literature.
• Do not make any alterations or modifications to the machine.
• If there are any questions and/or problems, please contact the BLUM Customer Service Department at 1-800-438-6788 or
www.blum.us
• Failure to follow these instructions and the warnings provided on the machine may result in serious bodily injury or death.
• For additional copies of the Operator's Manual or if there are questions with regard to the safe operation of this machine, contact
BLUM USA at 1-800-438-6788.
D - Safety information
(3.1) to OFF before re-tooling or performing any work on drill bits..
(3.1)
7
BA-106/1EA M53.10XX