7) Boring Depth Stop (4.11); 8) Setting Speed Of Downward Stroke; 9) Checking Stroke Brake; 10) Setting The Stroke Brake - BLUM MINIPRESS P Operator's Manual

4.12
4.11
4.13
3.1
3.2
4.14
4 - Concealed hinge installation
4.1.7) Boring depth stop (4.11)
Another option to maintain a constant boring depth is to install the boring depth stop.
When the boring depth stop is installed, the boring depth is always 13 mm regardless of
the thickness of the work piece.
Installing the boring depth stop:
• Drill power switch to OFF
• Remove drill bit
• Push boring depth stop into the locking holes of the retainer ring
engages and turn 90 degrees with force.
• Attach drill bit
! IMPORTANT:
The drill bit length must be set to 57 mm. (See point 4.1.2). The knurled
hand wheel should be adjusted so that it doesn
(See point 4.1.5)

4.1.8) Setting speed of downward stroke

The stroke speed is set via a steel knurled knob
• Faster: Turn screw
(4.13)
• Slower: Turn screw
(4.13)

4.1.9) Checking stroke brake

The stroke brake slows down the speed of descent just before the drill bit enters the
wood. (This extends the life of the drill bit and ensures clean edges)
• Drill power switch (3.1) to OFF
• Keep the machine's work area (A) free.
• Press the drill/press stroke button

4.1.10) Setting the stroke brake

The brake is set by turning the brass knurled knob
• Hard wood: Turn knurled knob
Brake will be applied harder.
• Soft wood: Turn knurled knob
Brake will be applied less.
15
(4.13) on the back of the cylinder.
to the left
to the right
(3.2) and observe the head movement.
(4.14)
(4.14) to the right:
(4.14) to the left:
(4.12) until it
‚
t limit the boring depth.
on the side of the cylinder.
BA-106/1EA M53.10XX