Hardware Insertion Error - BLUM MINIPRESS P Operator's Manual

8.2 - Hardware insertion error

Error Cause
Hardware cannot be The air pressure is too low
inserted or only with
great difficulty
Insertion ram or swing arm is driving
against an object (e.g. ruler stop)
The surface of the work piece is too hard
Holes are not deep enough
The hole diameters are too small
The insertion ram has shifted or turned
Chips are in the holes
Swing arm is not set properly
8 - Troubleshooting
Solution
Air pressure must be 80-100 psi.
Remove object
Chamfered holes
See point "Boring depth not reached"
Table spacers are missing
Check drill bits and replace if necessary
Set insertion ram
Remove chips from holes
Check swing arm setting
25
Comment
See point 2.2.2
none
Use slip-on counter-
sink
none
See point 2.1.5
none
See point 4.1.16
none
See point 4.1.19
BA-106/1EA M53.10XX