19) Checking The Tilt Adjustment Of The Swing Arm (4.8); 20) Inserting The Concealed Hinge - BLUM MINIPRESS P Operator's Manual

2.7
4 - Concealed hinge installation
4.1.19) Checking the tilt adjustment of the swing arm
• Swivel down swing arm
• Check whether or not the concealed hinge is aligned with the bored holes.
• If it is misaligned, this can be caused by two things:
a) Swivel arm (4.8)
- Use the screw to correct this setting
b) Insertion ram is off-center:
- Correct this setting using the adjustment screws
! IMPORTANT:
If the drill/press stroke button
millimeters, the boring unit moves downwards at creep speed.

4.1.20) Inserting the concealed hinge

3.1
ATTENTION:
3.2
All items except for the work piece should be removed from the work
3.3
area of the machine. Keep your hands out of work area (A).
• Press the drill/press stroke button
4.8
completely.
• Release drill/press stroke button (3.2).
• Swivel up swing arm
• Loosen the clamps by pressing the
clamp button (3.3)
• Remove door from the work table or push to the next stop.
(4.8) to the stop.
is not set vertical.
(4.21)
(3.2)
(3.2) until the concealed hinge is inserted
(4.8) .
18
(4.8)
(4.22) on the insertion ram.
is only lightly pressed a few
BA-106/1EA M53.10XX