Machine Setup; Unpacking And Assembly; 1) Machine Space Requirement; 2) Unpacking Machine And Attaching To A Suitable Table - BLUM MINIPRESS P Operator's Manual

H
B
2.1
2.2
1.
2.

2 - Machine setup

2.1 - Unpacking and assembly

2.1.1) Machine space requirement

Height (H) = 30-3/8" (771 mm)
Width (W) = 27" (684 mm)
Depth (D) = 27-1/4" (690 mm)
T

2.1.2) Unpacking machine and attaching to a suitable table

• Open box
• Use two people to lift the machine onto the work table
ATTENTION:
The machine weighs approx. 101 lbs.
The table or stand must be of sufficient stability to accommodate this
The machine should not be set up in a wet environment. The area must
be dry.
• Pre-drill holes and then attach machine
2.1.3) Positioning base ruler
• Place ruler on mounting bracket
• Line up the "0" mark on the center ruler with the "0" mark on the machine base
• Clamp ruler

2.1.4) Attaching ruler stops

2.7
• Loosen clamping screw until the location plate protrudes 10 mm
• Attach ruler stop to ruler at an angle and stand upright
• Tighten clamping screw
! IMPORTANT:
This procedure can also be used to set a stop between two already
installed stops.
3.

2.1.5) Attaching work table

a) Work table (Blum reference number MZA.5300)
• Set work table on runner plate
• Attach work table to runner plate
b) For details of
how to construct a work table, see Chapter 9
IMPORTANT:
!
With plastic spacers installed, the distance between the top of the
ruler and the top of the worktable is 6.6 mm. Without the spacers the
difference is 13.6 mm (for work pieces with a profile edge)
(2.1)
(2.2)
10
using the proper screws/bolts.
BA-106/1EA M53.10XX