Mounting Plate Installation; Wing Mounting Plate Installation; 1) Required Parts; 2) Setting Drill Bit Length - BLUM MINIPRESS P Operator's Manual

5.2 5.1 4.3
5.1 5.2
4.3
4.3 5.1
4.3
5
5
4.6
5.3
2.2
2.7

5 - Mounting plate installation

5.1 - Wing mounting plate installation

5.1.1) Required parts

• Drill bits:
1 x ø5 mm clockwise
1 x ø5 mm counterclockwise
• Cover caps
• Cabinet side
• Wing mounting plate with system screws

5.1.2) Setting drill bit length

(see point 4.1.2)

5.1.3) Setting boring pattern

• Pull out spring loaded boring head securing knob
• Simultaneously move the lever
• Release spring loaded boring head securing knob
5.2

5.1.4) Installing drill bits into the chuck

(see point 4.1.4)

5.1.5) Checking boring depth setting

(see points 4.1.5 / 4.1.6 / 4.1.7)

5.1.6) Setting the stroke speed

(see points 4.1.8 / 4.1.9 / 4.1.10)

5.1.7) Setting the boring distance

• Set the desired dimension using the hand wheel
• Example: SYS-37 mm
5.1.8) Setting ruler stops
Set the ruler stops
IMPORTANT:
!
Indicator edge is on the inside of the sliding part.
(5.1) (marked in black)
(5.2) (marked in orange)
(4.3)
(4.6) to the "Hole group" symbol
(2.7)
(2.7) to the desired dimension and clamp.
19
(4.5)
(5.3)
(4.5)
BA-106/1EA M53.10XX