C - How To Use This Manual - BLUM MINIPRESS P Operator's Manual

5.1.12) Releasing clamps (optional)
6 - Other installation
6.1 - Boring hole groups
6.1.1) Required parts
6.1.2) Setting drill bit length
6.1.3) Setting boring pattern
6.1.4) Inserting drill bits into the chuck
6.1.5) Checking boring depth setting
6.1.6) Setting stroke speed
6.1.7) Setting boring distance
6.1.7) Setting the ruler stops (2.7)
6.1.9) Placing cabinet side on the work table and pushing up against the stop
6.1.10) Setting clamps (optional) (4.17) to the material thickness
6.1.11) Boring
6.1.12) Releasing clamps (optional)
7 - Maintenance and service
7.1 - Maintenance
7.1.1) Maintenance
7.1.2) Damaged clutch
7.1.3) Replacing the operational status indicator
7.1.4) Releasing cylinder air pressure
8 - Troubleshooting
8.1 - Error during boring
8.2 - Hardware insertion error
8.3 - Function errors
9 - User-supplied work table
10 - Diagrams
10.1 - Electrical diagram
10.2 - Pneumatic diagram
11 - Technical data

C - How to use this manual

• Please keep a copy of the Operators' Manual accessible to machine operators.
• We recommend that you use the orientation diagram for easier identification of the parts being described.
• Individual sections are indicated by capital letters which makes it easier to navigate the instructions.
ATTENTION:
This exclamation point indicates important safety information that must be followed.
IMPORTANT:
!
This exclamation point indicates a comment. If this comment is not followed, then machine components as well as
the work piece itself may be damaged or the machine may be rendered inoperable and/or the work piece unus-
able.
(3.1) Component description codes correspond to the section where the component and its function is described. For example,
described in section 3.
B - Table of contents
5
20
21
21
21
21
21
21
21
21
21
21
21
21
21
21
22
22
22
22
22
22
23
23
25
26
28
29
29
29
30
(3.1) is
BA-106/1EA M53.10XX