Hinge Installation; Concealed Hinge Installation; 1) Required Parts; 2) Setting Drill Bit Length - BLUM MINIPRESS P Operator's Manual

4.4
4.2 4.1 4.2
4.2 4.1 4.2
4.3
4.1
4.2
8 8
35
4.3
4.10

4 - Hinge installation

4.1 - Concealed hinge installation

4.1.1) Required parts

• Bits:
1x ø 35 mm clockwise
2x ø 8 mm counterclockwise
4.3
• Cover caps
• Insertion ram MZM.00XX
for the respective concealed hinge)
• Dowelled hinge (press-in)

4.1.2) Setting drill bit length

• The total length of the drill bits (from bit-tip to adjustment screw)
should be 57 mm
• To correct drill bit length, adjust screw accordingly using a screwdriver
!

4.1.3) Setting boring pattern

• Pull out boring head securing knob
• Simultaneously move the lever
• Release boring head securing knob

4.1.4) Inserting drill bits

• Push drill bits all the way into the chuck (The flat section on the drill bit shank must be
4.2
in line with the set screw)
• Use a hex wrench to tighten the set screws
• Insert cover caps into the unused chucks (4.3). This will keep the chucks clean and
prevent the set screws from shaking loose

4.1.5) Setting boring depth

• Set boring depth using the bottom knurled hand wheel
(One turn equals 1.5 mm)
• Secure the bottom knurled hand wheel
(4.1) (marked in black)
(4.2)
(4.3)
(4.4) (see catalogue to determine the proper insertion ram
IMPORTANT:
All drill bits must be the same length
(4.6)
ATTENTION:
Disconnect the machine from the power suplly.
Drill power switch (3.1) to OFF
14
(marked in orange)
(4.5)
to the "Concealed hinge" symbol
(4.5)
(4.10)
(4.10) (lock)
(4.7)
BA-106/1EA M53.10XX