D - Safety Information; Safety Decals; Intended Use; Safety Instructions - BLUM MINIPRESS P Operator's Manual

D.1 - Safety decals
Before connecting your machine to a power source, be sure to read and understand ALL safety instructions, warning
labels and the Operators' Manual!
Wear safety glasses or full face shield when setting up, operating or servicing this machine.
Keep unauthorized people away from the machine. Only one person at a time must operate this machine.
Keep hands away from the drill bits or swing arm during the boring or insertion process.
Do not remove safety devices - danger of injury.
Keep hands away from the danger zone of the clamps. - danger of being crushed
Laser radiation - do not look into the laser beam!
Laser class 2
The cylinder remains pressurized after pneumatic power is disconnected from machine. To release cylinder, see section
7.1.4 for cylinder depressurization instructions.
D.2 - Intended use
• This machine is designated for commercial and industrial applications and shall be used by fully trained professionals only. The
machine is only intended for the boring and insertion of Blum hardware into panels of wood or laminated particle board. The ma-
chine should not be used for any other purpose.
• The machine is not explosion-proof. It should not be set up near a paint finishing system or any other environment where an explo-
sion hazard exists
• Do not setup or use the machine in a wet environment or in an environment which may become wet.
D.3 - Safety instructions
• Read and understand this Operators' Manual before setting up, operating, or servicing the machine.
• Only qualified electricians should connect electrical power to this machine or perform maintenance or service operations on electri-
cal components of this machine.
• To prevent electrical shock, do not operate the machine near wet areas or where the machine may become wet.
• To minimize fire risk, this machine must be connected to dust suppression system (see section 2.4).
• Machine is intended for one person operation only.

D - Safety information

6
BA-106/1EA M53.10XX