4�7�- Configuration; 4�7�1� Impulse Output Weight - Circutor CEM-C10 Instruction Manual

4�7�- CONFIGURATION
In the setup menu you can:
 Program the weight and type of impulse output.
 Program the communications.
 Program the display screen.
 Program the cost of the energy and the CO
 Delete the partial energy meters.
The standby mode is activated again when no key is pressed for 60 seconds.
Long press the
to display the home screen,
Long press the
4�7�1� Impulse output weight
Long press the key to view the value to be programmed.
When the desired value is shown on the screen, move onto the next digit with a long press on the
key, allowing the remaining values to be modified.
To validate the data, move to the last digit and long press the
appear (
Figure 11
18
key in the standby mode screen to open these setup screens. Short press the key
:
Figure 10
Figure 10: Programming home screen
key to access the first programming step.
This is the home screen for entering the weight of the impulse output.
To write or modify the value, short press the
increasing the value of the flashing digit.
) indicating that the programming value has been saved.
emissions
2.
key; the validation screen will
CEM-C10
key repeatedly,
Instruction Manual