4�7�4� Transmission Speed ( Baud Rate) - Circutor CEM-C10 Instruction Manual

When the desired value is shown on the screen, move onto the next digit with a long press on the
key, allowing the remaining values to be modified.
To validate the data, move to the last digit and long press the
appear (
Figure 11
After a few seconds viewing the screen shown on
address programming main screen.
Minimum value: 1.
Maximum value: 254
Short press the
4�7�4� Transmission speed ( Baud rate)
Note: This is only displayed if there is a
of units) connected to the unit.
Long press the key to view the value to be programmed.
To validate the data, long press the
that the programming value has been saved.
After a few seconds viewing the screen shown on
speed programming main screen.
Short press the
20
To write or modify the value, short press the
increasing the value of the flashing digit.
) indicating that the programming value has been saved.
key to access the next programming step
This is the home screen for entering the transmission speed.
The transmission speed (Baud rate) is selected on this screen, and may
be: 9600, 19200 or 38400�
Short press the
key to access the next programming step.
, the system returns to the Peripheral
Figure 11
(communications interface for the CEM family
CEM M-RS485
key to browse the different options.
key and the validation screen will appear (
, the system returns to the Transmission
Figure 11
CEM-C10
key repeatedly,
key; the validation screen will
) indicating
Figure 11
Instruction Manual