Dual Mode Programming - Plockmatic 510 Operating Instruction

Increasing capacity of the CF/ACF 510 (Feeding and Collating)

Dual Mode Programming

28
After a successfully completed calibration, the Run
Menu will be shown. If you are satisfied with your
programmed settings, press [Start] to start the job.
This screen will be shown while the job is running.
There are two ways of stopping the job using
either of the two stop buttons.
Either press the [STOP!] button to immediately
interrupt the job or press the [Stop] button to let
the machine complete the feeding sequence
before the job is stopped.
To start the job again, press the [Start] button and
the job will continue where it was interrupted.
Note
If a jam should occur when the [Stop] button is
pressed, the machine stops immediately instead
of completing the feed sequence. This means
that the machine not necessarily starts with the
first sheet in the feed sequence if it is restarted.
Therefore it is important to reload/unload bins in
use to correct the sequence before starting.
Press the [ ] and [ ] buttons to select whether
bin 2 should run as Feeder (F) or Collator (C) and
press [OK].
Press the [ ] and [ ] buttons to set the number
of sheets to be fed from the Feeder section and
press [OK].