Feeder Programs
Basic programming
When programming the feeder function using the basic option the feeder is pre-pro-
grammed in four blocks. You can set the feeding sequences as desired, choosing the
order the blocks shall be fed from and the number of sheets to be fed from each block.
Note
By choosing Advanced programming the blocks can be set up as desired. Advanced pro-
gramming is explained later in this section.
There are two different feeder programs. They are
selected directly from the Mode menu. Use the [
or [
] buttons to select preferred program and press
[OK].
Press [ ] and [ ] buttons to set the number of
sheets to be fed in sequence A.
When this is done press [
programming the B, C and D sequence.
The letters are showing the number of sheets to
be fed from each block and the order in which they
are fed.
When the feeder is programmed as desired press
[OK] to continue.
]
] to continue
25