Feed Pressure Lever; Stacker; Internal Stacker - Plockmatic 510 Operating Instruction

Feed pressure lever

With the feed pressure lever you can change the pressure on the feed roller. There are
three different positions. Follow recommendations below.

Stacker

The
Collator / Feeder
stacker. The setup for the stacker is shown in Section 2, Running the system.

Internal Stacker

Side and length stops
16
Low mark position is recommended when handling printed
sheets that easily smear. This can also be recommended
if you have loaded the machine with thin sheets. The
separation function will be lower.
Use this position if the current sheets are:
A4, 8,5x11", 8,5x14" and weigh up to 140 gsm.(37lb Bond)
A3, 11x17" and weigh up to 120 gsm.(32 lb Bond)
Use this position if your sheets weigh more than the
weight recommended in the 0 position.
510 can be used with a bookletmaker and it also has an internal
When the integral stacker is to be used, slide
the adjustable side and length stop to the
correct sheet size. Notice that there are two
different scales on the side stops. One for
straight stacking and one for offset stacking.
Note
The side stops are connected and centered.