Table of Contents
Advertisement
Alternate Cover Mode
Block Mode
Manual Bin Select Mode
22
This program doubles the loading capacity of covers
by allowing you to load the cover sheets in both bin
1 and bin 2. Use this program when the covers are
thicker than the body sheets. Select Alternate Cover
Mode with the [
] or [
Program menu. In the mode menu, press the [OK]
button to confirm.
Note
The other bins are in Auto Bin Mode and needs no
programming.
This program allows you to reload the collator while
running by loading the set two or three times in sepa-
rate blocks. When any of the bins in one block be-
comes empty, the collator automatically switches to
the other block. It is possible to load up to 5 sheets
per set.
Mark the number of bins to be used (i.e. the number
of sheets in the set) in the first block with the [ ] or [ ]
button. Press [B] to confirm.
When the [B] button is pressed, the collator will sug-
gest the next bins to be used by marking them with a
B. You may select other bins than suggested by mov-
ing the block with the [
confirm or [C] to add a third block.
Note
The example shows how to run a set of two sheets.
Load sheet one in bin 1 (first block) and bin 3 (second
block). Sheet two should consequently be loaded in
bin 2 and bin 4.
This program allows you to use empty bins for new
jobs without removing already loaded sheets. Use the
[
] or [
] buttons to choose bin and press the [ ]
button to activate the bins you want to use for the new
job. To deselect a bin, use the [ ] button. Load the
sheets into the empty bins. Press [OK] to confirm.
] buttons in the Collator
] or [
] button. Press [OK] to
Hide quick links:
Advertisement
Table of Contents
