Smartstart/Xl202 Installation Notes - Directed DBALL2 Installation Manual

Platform: DBALL2
Firmware: CHRYSLER7 Remote Start Ready Installation (RSR)

SmartStart/XL202 Installation Notes

The DBALL Remote Start Ready (RSR) solution offers three (3) configuration options to control your system; 3x OEM Lock
Remote Start Activation, RF Kits or SmartStart (all sold separately). This section provides specific installation information for
SmartStart and XL202.
SmartStart Revision A
SmartStart is optional and not included. It MUST be purchased separately.
Configuration Wires (White & Brown or Blue)
DBALL2
CABLE
The modules must be connected in a specific order. Refer to the Module Programming section for more information.
SmartStart Revision B
SmartStart is optional and not included. It MUST be purchased separately.
DBALL2
CABLE
The modules must be connected in a specific order. Refer to the Module Programming section for more information.
RF Kit
The optional XL202 and antenna are not included and MUST be purchased separately.
DBALL2
XOVER
1. Use the D2D Crossover (XOVER) cable that is provided with XL202, and NOT the one in the DBALL package.
2. The modules must be connected in a specific order. Refer to the Module Programming section for more information.
RF Kit & PKE Combination
Refer to the Passive Keyless Entry (PKE) Installation Guide (N2102T) for detailed wiring information.
RF Kit, PKE & SmartStart BT Combination
Refer to the Passive Keyless Entry (PKE) Installation Guide (N2102T) for detailed wiring information.
Cut Brown or Blue Loop
4 pins
2 pins,
not used
D2D (4 pins, white)
Configuration Wires (Gray & White)
Connect Gray wire to (-) Ground
5 pins
4 pins
2 pins,
not used
D2D (4 pins, white)
LED
LED
XL202
Prog.
Button
OR
SmartStart
LED
THIS SIDE UP
Rev.: 20160610
Page 7
© 2016 Directed. All rights reserved.