Troubleshooting; Appendix; Disposal Of The Appliance - Silvercrest SEF3 2000 C3 Operating Instructions Manual

Troubleshooting

PROBLEM
The appliance is not
working .
or
The Power control lamp 0
does not light up .
The Ready control lamp 9
does not light up .
If the malfunction cannot be corrected with the above suggestions, or if you have found some
other kind of malfunction, please contact our Customer Service department .

Appendix

Disposal of the appliance

Under no circumstances should you dispose of the appliance in
normal household waste .
This product is subject to the provisions of European Directive
2012/19/EU .
Dispose of the appliance via an approved waste disposal company or your
municipal waste disposal facility . Please observe applicable regulations .
Please contact your waste disposal facility if you are in any doubt .
Your local community or municipal authorities can provide information on how to
dispose of the worn-out product .
The product is recyclable, subject to extended producer responsibility and is
collected separately .
■ 40 │ GB │ IE
POSSIBLE CAUSE
The appliance is not connected
to a mains power socket .
The appliance is damaged .
The On/Off switch 8 has not
been activated .
The thermal cut-out has been
triggered .
The selected temperature for
the cooking oil/fat has not
been reached .
POSSIBLE
SOLUTIONS
Connect the appliance to
a mains power socket .
Contact the Customer
Service department .
Press the On/Off switch 8 .
Switch the device off at
the On/Off switch 8 and
disconnect the mains power
plug from the mains power
socket . Wait until the appli-
ance has cooled down .
Wait a few minutes until the
required temperature has
been reached .
SEF3 2000 C3