New Holland Workmaster 50 Operator's Manual page 91

WARNING
Pinch hazard!
Always use the position control lever when
attaching, detaching, or transporting imple-
ments.
Failure to comply could result in death or se-
rious injury.
Most implements can be attached to the tractor as follows:
Position the tractor so that the lower link hitch points are
level with and slightly ahead of the implement hitch pins.
Carefully bring the tractor rearwards to match the trac-
tor and implement hitch points. First attach the left-hand
lower link (1) then by adjusting the levelling box (2) attach
the right-hand lower link (3).
Lengthen or shorten the top link (4) until the implement
mast pin (5) can be inserted through the mast and upper
link of the implement.
Adjust stabilizers (4) to limit side to side movement of the
lower links and attached implement. Adjust stabilizers so
that there is not any interference with tires and lower links
when moving attached implement side to side.
NOTICE: When attaching mounted or semi mounted im-
plement to the three-point linkage, ensure that there is ad-
equate clearance between the implement and the rear of
the tractor. The clearances in the raised position should
be checked by raising the implement carefully with posi-
tion control lever. With the implement fully raised there
must be at least 100 mm (4 in). clearance between the
implement and the nearest part of the tractor.
NOTICE: Ensure that the telescoping stabilizers (4) are
adjusted to suit the equipment. Remove the swinging
drawbar, if close mounted equipment is being attached.
6 - WORKING OPERATIONS
NOTE: Before attaching implements read the following
text carefully.
W0466A
6-7
1
GNIL14TR00562AA
2
20108789
3
GNIL14TR00562AA