New Holland Workmaster 50 Operator's Manual page 100

Tie Rod - Steering (Right-hand side - Illus-
trated)
1. The tie rod located behind the axle must be disen-
gaged to permit adjustment of the axle.
2. The tie rod is telescopic and consists of a central hol-
low tube with a solid extendible section at each end.
3. Remove the locating bolt (1) from both ends of the tie
rod.
4. The position for the setting of the steering cylinder will
also change respectively.
5. Left-hand and right-hand axle telescopic sections,
passing the securing bolts through the center beam
and telescopic sections, as indicated in 3, see chart.
6. Remove the nut (1) at the right-hand end of the tie rod
and withdraw tie rod from arm (2)
7. Loosen the bolt (3) and rotate the threaded end to
shorten or lengthen tie rod assembly until the toe-in
is correct. Tighten all bolts/nuts securely.
6 - WORKING OPERATIONS
6-16
5
86090130N
6
20108792