Table of Contents
Advertisement
7.13 Parameter lock with event input
The parameters of the UREG200 can be locked via
the DIP switches (see chapter 4.3) on the device
and/or via the event input Terminals 17 and 18
(see chapter 5.10).
Setting for locking with the event input:
EIFN = LOCK (see chapter 7.1)
If the switch at the event input is closed, all parameters are locked against adjust-
ment. If the switch is open, the settings of the DIP switches on the device apply.
8. Calibration
Calibration of the UREG200 is to be performed exclusively by the
manufacturer or specially trained personnel.
Instructions for calibration will be issued during training. If you feel that your
UREG200 needs to be calibrated, please contact:
Promesstec GmbH
Niedersachsenstraße 4
48465 Schüttorf
Activating the calibration interrupts the control loop, make sure that
the process is switched off, qualified personnel and suitable
equipment are available is.
Never activate the calibration out of ignorance or curiosity, this can lead to the
loss of the current calibration values and the controller must be sent to the fac-
tory for recalibration at a charge.
promesstec GmbH I Niedersachsenstraße 4 I D- 48465 Schüttorf I Tel.:+49 (0)5923/ 90 229 0 I Fax:+49 (0)5923/ 90 229 29
Parameter lock
External switch to terminal
EIFN = LOCK set
All parameters are locked.
Tel.: 05923/90 229 0
Fax: 05923/90 229 29
Internet:
www.promesstec.de
E-Mail: office@promesstec.com I Internet: www.promesstec.com
and
.
84
Advertisement
Table of Contents
