Table of Contents
Advertisement
6.23 Restoring factory settings
The controller factory settings can be found in tables 1.3 to 1.8. These basic values
are permanently stored in the UREG200 and can be restored as follows.
Turning on the recovery
Press
so often until
upper display appears
factory settings in °C or program 1 for °F. After that press
setting.
Attention: All previous settings will be lost, make sure you have sa-
ved the configuration as a backup or made a note of it in case you
still need it.
promesstec GmbH I Niedersachsenstraße 4 I D- 48465 Schüttorf I Tel.:+49 (0)5923/ 90 229 0 I Fax:+49 (0)5923/ 90 229 29
appears in the display. Then press
. Use the UP-DOWN keys to select program 0 for
E-Mail: office@promesstec.com I Internet: www.promesstec.com
, in the
for 3 sec. to apply the
71
Advertisement
Table of Contents
