Table of Contents
Advertisement
The UREG200 can be configured via the PC with
the UREG-config software. Make sure that your
PC has an appropriate interface or you have an
interface adapter.
Setting the data transmission
Go to the setup menu.
Activate the entire menu scope FUNC = FULL.
Depending on the installed module, set
COMM = 485 or 232 on and PORT = RTU.
Set an individual address in the ADDR parameter
for each controller operated on the same port.
Set the transmission rates (BAUD), the number of
bits (DATA), the parity (PARI) and the stop bit
(STOP) on the PC and controller in the same way.
For connection please refer to chapter 5.14 and
5.16.
promesstec GmbH I Niedersachsenstraße 4 I D- 48465 Schüttorf I Tel.:+49 (0)5923/ 90 229 0 I Fax:+49 (0)5923/ 90 229 29
Benefit RS485
Long transmission up to 1 km
Up to 247 participants
Benefit RS232
Direct connection to the PC
Order code:
UREG200-x-x-x-1 for RS232
UREG200-x-x-x-2 for RS485
RS485 Settings:
FUNC=FULL
COMM=485
PORT=RTU
ADDR=Address
BAUD=Baud rate
DATA=Number of bits
PARI=Parity
STOP=Stoppbit
RS485 connection:
RS232 Settings:
FUNC=FULL
COMM=232
PROT=RTU
ADDR=Address
BAUD=Baud rate
DATA=Number of bits
PARI=Parity
STOP=Stoppbit
RS232 connection:
E-Mail: office@promesstec.com I Internet: www.promesstec.com
79
Advertisement
Table of Contents
