Table of Contents
Advertisement
6.6 Heating-cooling control
Six different controller configurations can be set for the heating-cooling control.
Please refer to the following table for the parameter settings:
Note: The ON-OFF control can lead to strong process fluctuations.
The P (PD) control can also lead to slight deviations from the setpoint. For a
stable and low-deviation process result, the PID heating-cooling control is
required.
Further settings required: O1TY, CYC1, O2TY, CYC2, A2SP, A2DV,
Typical settings OUT1 /OUT2:
output SSR: CYC1/CYC2 = 0,5 ~ 2 sec.
output relay: O1TY/O2TY = 10 ~ 20 sec.
Analogue output:
promesstec GmbH I Niedersachsenstraße 4 I D- 48465 Schüttorf I Tel.:+49 (0)5923/ 90 229 0 I Fax:+49 (0)5923/ 90 229 29
O1TY & O2TY are set depending on the control configuration.
CYC1 & CYC2 depending on O1TY resp. O2TY
CYC1/CYC2 = not adjustable (hidden)
E-Mail: office@promesstec.com I Internet: www.promesstec.com
48
Advertisement
Table of Contents
