Table of Contents
Advertisement
The following values can be displayed:
PVHI/PVLO show the maximum and minimum value of
Parameter overview:
the process, these values are stored non-volatile and
are also available after a power failure. Press
for 6
sec. to delete the values.
MV1/MV2 show the current values for outputs 1 and 2.
DV Shows the current difference between process and
setpoint value (PV – SV)
PV1 shows the current process value of input 1
PV2 shows the current process value of input 2
PB displays the current proportional band value of the
controller
TI displays the current integral time
TD displays the current differential time
CJCT displays the current temperature of the internal
cold junction in °C (independent of the controller unit)
PVR displays the current rate of change in °C/min.
(depending on the setting also °F/min. or PU/min.).
The value can be negative if the PV is decreasing.
PVRH/PVRL displays the maximum and minimum va-
lues of PVR. PVRH is a positive value, PVRL is a ne-
gative value.
Switching off the display mode
The display mode remains active until it is switched off. Press
together to exit
the display mode.
70
promesstec GmbH I Niedersachsenstraße 4 I D- 48465 Schüttorf I Tel.:+49 (0)5923/ 90 229 0 I Fax:+49 (0)5923/ 90 229 29
E-Mail: office@promesstec.com I Internet: www.promesstec.com
Advertisement
Table of Contents
