Table of Contents
Advertisement
•
The instructions for the assembly, operation, and maintenance include clear warnings concerning
precautions to
avoid possible exposure to hazardous laser radiation.
Light Intensity Hazard Distance for G100 Series
This projector may become Laser Product-Risk Group 3 (RG3) when installed with lens with throw ratio
greater than 2.0. Permanent eye injury is possible when exposed to the high intensity light beam within the
hazard distance (HD).
Lens information with resolution WUXGA (0.96"):
Projection Lens
Risk Group
Throw ratio
0.38 - 2.0
2.0 - 4.0
4.0 - 7.2
Follow the precautions to avoid light intensity hazard.
•
NEVER look into the lens! High intensity light beam.
•
Permanent eye injury is possible when exposed to the high intensity light beam within the hazard distance.
•
Operators shall control access to the light beam within the hazard distance or install the product at a height
that will prevent eye exposure within the hazard distance.
•
Do not place any reflective objects in the light path of the projector.
1.2 Important safety instructions
To prevent the risk of electrical shock
•
This product should be operated from a mono phase AC power source.
•
This apparatus must be grounded (earthed) via the supplied 3 conductor AC power cable. If none of the
supplied power cables are the correct one, consult your dealer. If you are unable to insert the plug into the
outlet, contact your electrician to replace your obsolete outlet. Do not defeat the purpose of the grounding-
type plug.
•
Do not allow anything to rest on the power cord. Do not locate this product where persons will walk on the
cord. To disconnect the cord, pull it out by the plug. Never pull the cord itself.
•
Use only the power cord supplied with your device. While appearing to be similar, other power cords have
not been safety tested at the factory and may not be used to power the device. For a replacement power
cord, contact your dealer.
•
Do not operate the projector with a damaged cord. Replace the cord.
•
Do not operate the projector if the projector has been dropped or damaged until it has been examined and
approved for operation by a qualified service technician. Position the cord so that it will not be tripped over,
pulled, or contact hot surfaces.
•
If an extension cord is necessary, a cord with a current rating at least equal to that of the projector should
be used. A cord rated for less amperage than the projector may overheat.
•
Never push objects of any kind into this product through cabinet slots as they may touch dangerous
voltage points or short out parts that could result in a risk of fire or electrical shock.
•
Do not expose this projector to rain or moisture.
•
Do not immerse or expose this projector in water or other liquids.
•
Do not spill liquid of any kind on this projector.
•
Should any liquid or solid object fall into the cabinet, unplug the set and have it checked by qualified
service personnel before resuming operations.
•
Do not disassemble this projector, always take it to an authorized trained service person when service or
repair work is required.
•
Do not use an accessory attachment which is not recommended by the manufacturer.
G100–W22, G100–W22 3D
RG2
RG3
1940mm
RG3
4565mm
Hazard Distance (HD)
G100–W16, G100–W16 3D,
G100–W19, G100–W19 3D
NA
Safety
NA
1165mm
4120mm
R5913459 /00
G100
9
Advertisement
Table of Contents
