Table of Contents
Advertisement
User controls
Orientation
Setting the projection orientation according to the projector's installation direction:
•
Ceiling Mount: Enable/disable the function for ceiling mount installation.
•
Direction: Select Front Projection or Rear Projection based on the projector's relative position to the
screen.
Aspect Ratio
Set the aspect ratio of the projected image. The available options are:
•
Auto (default)
•
4:3
•
16:9
•
16:10
•
Letter boxing
•
Native
The projector can detect the image size from the connected source. Select Auto to display the
detected image size.
Scale
Digitally scale the image size and position to fit onto the actual projection surface.
Setting
Possible actions
Digital zoom Digitally adjust the size of the projected image.
•
Proportional: Enable the function to have the image's height and width changed at the
same ratio.
•
Horizontal: Use the left and right arrow keys to change the width of the projected image.
•
Vertical: Use the up and down arrow keys to change the height of the projected image.
Digital shift
Adjusts the position of the display area within the lens offset range. Use the arrow keys to shift
the projected image either horizontally or vertically.
Reset
Returns all scale settings to the factory default values.
First perform a digital zoom. Only perform a digital shift when the image has been zoomed in/out to
the desired position.
Signal
Configure the settings to correctly project the input signals and transfer the output signals.
Setting
Possible actions
Auto signal
When Auto Signal is enabled, the projector automatically detects and selects the input signal.
Once an input source is selected, you can press the Input key on the keypad or the input button
on the remote control to switch to the other available source(s).
If Auto signal is disabled, pressing the Input key or button will bring up the Input Signal
submenu.
Input signal
Select an input signal from the source list. The available input sources are VGA, HDMI-1,
HDMI-2, DVI-D, DisplayPort, 3G-SDI and HDBaseT.
Backup input Backup Input function allows the user to set up two input sources with the same timing
specification. Upon loss of one input source, the projector automatically switches to the other
source.
This function is useful for installations and setups requiring uninterruptedly displaying the
content source, such as live show, exhibition, and critical control rooms.
•
Auto Switch: Enable this option to automatically switch to the backup input source when
the current source fails.
•
Current Signal: Displays the current active signal.
•
First Input: Select a signal as the first input source.
36
R5913459 /00
G100
Advertisement
Table of Contents
