Table of Contents
Advertisement
Setting
Possible actions
•
Second Input: Select a signal as the second input source.
•
Backup Input Status: Display the function status.
Once a selected source is activated, the OSD menu will list the signal's resolution, Horizontal
refresh rate and color space.
The Backup Input status will be active when the following conditions are met:
•
Auto Switch is enabled.
•
The two selected input sources have the same timing specification
•
The two selected input sources are active at the same time
•
The projector is displaying one of the two sources.
VGA
Setup the VGA source by selecting the proper Phase, H. Position, V Position and Resolution.
HDMI
Setup the projector's HDMI ports.
•
Output: Select an HDMI port to output the signal.
•
EDID: When receiving a HDMI signal, set the projector's EDID compatibility to display the
signal correctly. Select 1.4 for the input devices with HDMI 1.4, or 2.0 for HDMI 2.0 devices.
HDBaseT
Configure the HDBaseT settings to correctly display the HDMI signal transfered via the
HDBaseT port.
•
EDID: When receiving a HDMI signal via HDBaseT, set the projector's EDID compatibility to
display the signal correctly. Select 1.4 for the input devices with HDMI 1.4, or 2.0 fo HDMI
2.0 devices.
Auto Signal
If enabled, the system will automatically synchronize the projector to the recent connected
Resync
input source every time you switch the input source.
Edge mask
The edge blending function allows you to hide one or multiple edges of the projected image. You can use this
function to remove the video encoding noise on the edges of the video images.
Auto image setup
Automatically adjust the image to achieve better performance.
•
Auto Focus: Automatically adjust the image focus.
•
Auto Wall Color: Automatically adjust the image color to fit the color of the projection screen.
The auto image setup functions are performed via the built-in camera. Please make sure the
camera is not covered by any subjects. The auto adjustment process might take more than one
minute to complete.
Geometric correction (warp)
Configure the geometric settings to reshape the image for different projection surface. These options are
divided in two options:
•
Basic warp: Including Keystone, pincushion and 4–Corners
•
Advanced warping: Grid points, Warp inner, Warp sharpness and more.
Basic Warp:
•
Keystone: Keystone function is used to adjust the images in asymmetric rectangle shape.
-
Horizontal: Adjust the left and right side of the projected image to make it an even rectangle. It is used
or the images with unequal left and right sides.
Image 5–2
User controls
R5913459 /00
G100
37
Advertisement
Table of Contents
