Table of Contents
Advertisement
User controls
•
Daylight Saving Time: Configures the daylight saving settings if required.
-
Daylight Saving Time: Enable or disable the daylight saving function.
-
Daylight Adjustment: Set the difference between standard time and daylight saving time.
-
DST Start: Set the date and time to start the daylight saving time.
-
DST End: Set the date and time to end the daylight saving time.
•
NTP Server: Specify an IP address for the NTP Server, which is required for the network clock mode.
•
Time Zone: Set a time zone for the network clock mode.
•
Update interval: Set the date and time update interval.
•
Apply: Apply date and time modifications.
On Screen Display (OSD)
Set up the on screen display menus.
•
Menu location: Select the menu location from Top left, Top right, Center, Bottom left, and Bottom right.
•
Menu transparency: Set the menu transparency level.
•
Menu timer: Set the length of time the menu displays on the screen.
•
Show message: Enable or disable the corner information messages, such as input source, IP address,
and so on.
•
Background: Set a background color to display when no input signal is detected. The available options
are Blue, Black, White, and Logo.
•
Reset: Reset the menu settings to default factory values.
Logo setup
Set up the logo for the startup screen.
Schedule
For more info on scheduling, see "Scheduling", page 52.
Standby mode
Setup the projector standby mode.
•
Standby Mode: Minimum power consumption (0.5 Watt) which does not allow network controlling.
•
Network Standby Mode: Low power consumption (< 2 Watt) which allows the LAN module to enter sleep
mode and supports to be woken by Wake on LAN (WoL). When the LAN module is woken by WoL, the
projector is ready to receive commands over the network.
•
Communication Mode: More power consumption that allows controlling the projector over the network.
Power settings
Configure the projector's power settings.
•
Fast Power On: Enable the function to have the projector turned on and off with a fast speed. Some part of
the projector system is still running in the background if it is turned off when the Fast Power On is enabled
•
Signal Power On: Turn on this function to have the projector automatically turning on when connected to
HDMI input sources. It only applies to the standby projector set to Communication Mode.
•
Auto Power Off: Set an interval timer for the projector to automatically turn off if no signal is detected
within the specified time period. Press the t and u buttons to increase or reduce time. The available time
range is 0-180 minutes.
•
Sleep Timer: Set an interval timer for the projector to automatically turn off after operating for the specified
amount of time. The available time range is 0-16 hours.
•
Reset: Reset the power settings to factory default values.
Light source settings
Set up the light source to control the projector brightness.
•
Light Source Mode: Select a light source mode depending on the installation requirements. The available
options are Normal, Eco Mode, Quiet Mode, and Custom Mode.
•
Custom Brightness: When the Light Source Mode is set to Custom Mode, set up the custom brightness
level.
50
R5913459 /00
G100
Advertisement
Table of Contents
