Table of Contents
Advertisement
•
set up the Constant Brightness to maintain the image brightness at a specified level. A special algorithm is
designed to compensate the natural decay of brightness so that the image can be maintained at a fixed
brightness level.
-
Brightness Level: Adjust the brightness level from 30% to 100%.
Shutter
Set up the shutter behavior.
•
Fade-In: This function allows the fading in effect when turning off shutter. The time for the fading effect can
be adjusted from 0.5s to 5s.
•
Fade-Out: This function allows the fading out effect when turning on shutter. The time for the fading effect
can be adjusted from 0.5s to 5s.
•
Startup: Select the shutter behavior when turning on the projector.
-
Shutter On: Projector automatically turns on shutter after being powered on.
-
Shutter Off: Projector projects images normally after being powered on.
Security
Set up the projector security options.
•
Password: Enable to protect the projector with a password. If the user enters incorrect password three
times, a message will pop up warning that the projector shuts down in 10 seconds.
•
Security Timer: Specify the length of time the projector can be used without the password. Once the timer
counts to 0, the user must enter a password to use the projector. The timer restarts every time the projector
is turned on.
•
Set Password: Set the password required to operate the projector.
In the last minute before reaching a specified timer, including Auto Power Off, Sleep Timer, and
Security Timer, an on-screen message will pop up warning that the projector shuts down in 60
seconds. Press any button on the remote control or projector keypad to reset the timer and the
projector remains on.
Backlight
Set up the projector backlight options.
•
Keypad: Enable or disable the keypad backlight.
•
Power Key: Enable or disable the backlight for the power key.
High Altitude
Select On to increase the fan speed. To ensure the image quality and prevent damage to the projector, enable
High Altitude mode in high temperature, high humidity, or high altitude environment.
12V trigger
When enabled, the projector screen is automatically raised or lowered when the projector is turned on or off.
This function only works when the projector is connected to an electrical projector screen.
User data
User can save the projector settings as user data and reload the settings later.
•
Save all settings: Save all of the projector settings as user data. User can save up to 5 records.
•
Load all settings: Load the previously saved user data.
Reset
Reset the projector settings to factory default values.
•
Reset System settings: Reset the settings of the system menu to factory default values.
•
Reset all settings: Reset all of the projector settings.
•
Reset Selective: Reset the settings of one of the main menus. User can choose from Installation, Image
settings, Communication, and System settings.
User controls
R5913459 /00
G100
51
Advertisement
Table of Contents
